Author Topic: Correct way to do smooth scrolling in a tilemapper? (Read 9513 times)

Builderboy · « **Reply #15 on:** December 20, 2012, 12:27:42 pm »

It's worthy to note that smoothscrolling should not affect collision in any way, since scrolling is just a graphical effect.

BrownyTCat · « **Reply #16 on:** December 20, 2012, 12:40:12 pm »

The way I had the "smoother" set up in my original code was that it advanced the actual "X" by 1 once the offset reached 8 (or reduced it by 1 when the offset hit -8). I had problems with not being able to check horizontally and vertically, and everything eventually hit the fan. It should be obvious how poor I am at this if you check the original source at the end of this thread. My method was probably horribly incorrect, but I can't find a simple way to pull off movement that's not in multiples of 8, as I am the worst mathematician to exist.
Also, how do you actually display a variable in Axe? It just shows garbage symbols due to pointers, but I was sure a function existed to convert to string. I can just never find it. In BASIC, it's usually just:

Code: [Select]

Disp X

Builderboy · « **Reply #17 on:** December 20, 2012, 12:55:55 pm »

You should check out the command list for Axe, it has all sorts of useful information like that

you can use the >Dec command to display the value of a number instead of a string

Author Topic: Correct way to do smooth scrolling in a tilemapper? (Read 9513 times)

Builderboy

Re: Correct way to do smooth scrolling in a tilemapper?

BrownyTCat

Re: Correct way to do smooth scrolling in a tilemapper?

Builderboy

Re: Correct way to do smooth scrolling in a tilemapper?