Author Topic: Downgrade OS 3.1. (Read 3563 times)

thedarkplayer · « **on:** February 16, 2012, 04:02:43 pm »

hi, i buyed a ti nspire cas touchpad yesterday, after a lot of trouble i upgrade the OS to the 3.1.0.392 version, but there's a lot of problems, every key is switched, i press 2 and the calculator understan a, and the same is for every key, the touchpd doesn't works, do you know a solution?or a way to downgrade the os, even in the reset screen the calculator doesn't recognize the right key

Jim Bauwens · « **Reply #1 on:** February 17, 2012, 03:38:30 am »

It looks like your calculator things it has a 84+ keypad installed.
Try to remove the touchpad keypad and carefully check if the connector is not dirty. (Since a bad connection might trigger this)

thedarkplayer · « **Reply #2 on:** February 18, 2012, 09:06:15 am »

nothing change, TI will replace the calculator

DJ Omnimaga · « **Reply #3 on:** February 19, 2012, 03:16:03 am »

Hi and welcome here. When you turn the calc ON, does the screen shows a nearly empty screen with big pixels and stuff or a RAM cleared message? If that's the case, then the calculator thinks it has a TI-84 Plus keypad installed. If you see smaller pixels with a better resolution, then it's probably messed up or something and it registers the wrong keys, which seems less likely, though. In any case, it seems to be defective or something.

Did you have Ndless installed? Otherwise this shouldn't happen.

Jonius7 · « **Reply #4 on:** February 23, 2012, 10:55:49 pm »

Does non-TNOC OS have anything to do with it?

Author Topic: Downgrade OS 3.1. (Read 3563 times)

thedarkplayer

Downgrade OS 3.1.

Jim Bauwens

Re: Downgrade OS 3.1.

thedarkplayer

Re: Downgrade OS 3.1.

DJ Omnimaga

Re: Downgrade OS 3.1.

Jonius7

Re: Downgrade OS 3.1.