Can someone also compile Ndless for OS 2.1 plz? I don't want to downgrade to 2.0.1... Thx.

Thanks a lot, off to test it right now. Tell you the results in a minute.

EDIT1: Your ressources.tns file is 1 kB larger than the one from the repo. The problem must be in that.

EDIT2: Managed to successfully boot 2.1 CAS on 2.1 non-CAS.

EDIT3: Now that I've managed to make this work, I'm thinking about launching the 3.0 OS. Someone at the start of the thread said there were some problems, but what were they exactly?

Can someone also compile Ndless for OS 2.1 plz? I don't want to downgrade to 2.0.1... Thx.

I thought Ndless 2.1 was already available?

Strictly speaking, I think that "Ndless 2.1" is actually "Ndless 2.0 for OS 1.7/2.0.1/2.1"
And support for 2.1 ought to be part of the automated builds - if it's not, then the automated build system needs fixing.

compu, the string you're patching is used by the code that re-creates the folders. When hot-launching a single OS, I can't think of adverse effects, because a reboot would occur with a pristine OS, which would re-create the documents folder if it had been deleted; however, if hot-launching a second, patched OS from the first hot-launched OS actually works on a real calculator (maybe it doesn't, given how hot-launching is flaky, even with a bit of code to clear the caches), something might not work as expected if the documents folder is not re-created.
Watch out for that kind of interactions, which could also happen for the "tns" strings you're patching

The building blocks, derived from the tiosmod+amspatch building blocks, are at http://tict.ticalc.org/beta/phoenixmod-0.0.1.tar.bz2 . Untested.

Well, I hardly tested the CAS OS on the emulator at all
Let me check.

Did it work?

The building blocks, derived from the tiosmod+amspatch building blocks, are at http://tict.ticalc.org/beta/phoenixmod-0.0.1.zip . Untested.

404 error for me...

Launching Phoenix non-CAS 1.7.2741 from Phoenix CAS 1.7.2741 works on the emulator.

I've fixed the link in my previous post: http://tict.ticalc.org/beta/phoenixmod-0.0.1.tar.bz2 . Sorry

Quote from: Silver Shadow on April 26, 2011, 05:09:38 pm

EDIT: as I posted previously, the problem seems to come from the ressources.tns file, as brooom's version is 1 kB smaller than it should be.

So if you use brooom's ndless_installer and alberthro's ndles_resources you can run OSLauncher on OS2.1 without compiling ndless yourself?

I haven't tried doing that yet, but I suspect so.

Would you mind sharing the r388 ndless_ressources.tns plz?

EDIT: I've also tried connecting my Nspire to the PC with the CAS OS running. Strangely, the Computer Link recognized it as a non-CAS Nspire...

EDIT2: What exactly are the settings files that are different between OS versions? Are they created only during OS install or can you delete them and the OS recreates them again?