Author Topic: Doing too much with the TI-Nspire dock connectors?  (Read 14120 times)

0 Members and 1 Guest are viewing this topic.

Offline willrandship

  • Omnimagus of the Multi-Base.
  • LV11 Super Veteran (Next: 3000)
  • ***********
  • Posts: 2953
  • Rating: +98/-13
  • Insert sugar to begin programming subroutine.
    • View Profile
Re: Doing too much with the TI-Nspire dock connectors?
« Reply #30 on: October 16, 2011, 11:25:54 pm »
Well, theoretically you could hook it up with a small MOSFET circuit to get it to allow current from the battery when it gets a signal from the Serial, through Lua, but that's a little more soldering than just an LED (Not too bad though)

It's common for use in situations like this, where a low power signal needs to activate a high power drawing circuit.