Post by: Netham45 on January 31, 2007, 03:18:00 pm
I had an old headphone transmitter dock that is the PERFECT size for a calculator.
These pictures are a little big, about 1.5mb ea
http://home.comcast.net/~netham45/picutres/hub/1.jpg
http://home.comcast.net/~netham45/picutres/hub/2.jpg
http://home.comcast.net/~netham45/picutres/hub/3.jpg
http://home.comcast.net/~netham45/picutres/hub/4.jpg
http://home.comcast.net/~netham45/picutres/hub/5.jpg
http://home.comcast.net/~netham45/picutres/hub/6.jpg
http://home.comcast.net/~netham45/picutres/hub/7.jpg
http://home.comcast.net/~netham45/picutres/hub/8.jpg
http://home.comcast.net/~netham45/picutres/hub/9.jpg
Ok, so I had an old dock for a wireless headphone transmitter that I noticed fits a calculator perfectly.
What I did was
1) unscrew the bottom.
2) break out the circuit board with a screwdriver
3) find the center of it
4) drill a hole with a dremel tool
5) strip ALL of the insulation from a link wire(including the stuff at the base of the pins)
6) poke that through the hole
7) center it and tape it
8) tape some stuff to the bottom(I used a piece of the circuit board) so it wouldn't go down after I put the base on.
9) poke the wire through a little hole on the back
10) wired it up to a parallel linkcable, though you could use any.
11) screwed the base back on
12) put calculator on
13) watched it tip forwards and fall(heh)
14) unscrewed the base
15) taped some heavy washers on the back of the inside base.
16) screwed the base back on
17) put calculator on it
18) opened TiLP
19) tried a screenshot
20) cheered :psychedelic:
Post by: CureDesu on January 31, 2007, 03:21:00 pm
I smell something good.
Post by: DJ Omnimaga on February 01, 2007, 03:32:00 am
but whats the difference between using real headphones and this? sound cool tho
Post by: Delnar_Ersike on February 01, 2007, 05:07:00 am
Very niiice, I like!...How much? :P
Post by: Netham45 on February 04, 2007, 11:22:00 am
Post by: KermMartian on March 19, 2007, 03:01:00 pm
Duct tape ftw.Nice job.