Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - oln9488

Pages: [1]
1
Hot Dog's TI-83+ Z80 ASM for the Absolute Beginner / Re: Hot Dog's TI-83+ Z80 ASM for the Absolute Beginner--Discussion
« on: October 02, 2010, 10:38:55 pm »
thanks guys!  Sorry about the lack of completion on the previous example.  I had just threw an example in there without the rows or columns set yet to show what I was getting at.  I think oddly enough I understand asm better than basic at this point from learning hotdog's tutorials with little knowledge of basic.

thanks again!

2
Hot Dog's TI-83+ Z80 ASM for the Absolute Beginner / Re: Hot Dog's TI-83+ Z80 ASM for the Absolute Beginner--Discussion
« on: October 02, 2010, 05:59:55 pm »
thanks man.  I've got an easier question.  I got past the sprite clipping issue i was running into, but how do you use delay in asm?  I know in basic you can do for(A,1,1000):end and I could then do
while 1
getkey->Z
if z==24
then
for(A,1,1000):end
output(R,C," "
c-1->c
output(R,C,"O"
end
end

i want to be able to hit the right arrow, and my character/sprite continuously go right.  any thoughts?

3
Hot Dog's TI-83+ Z80 ASM for the Absolute Beginner / Re: Hot Dog's TI-83+ Z80 ASM for the Absolute Beginner--Discussion
« on: September 27, 2010, 11:36:38 am »
did you ever finish Lesson_18 by anychance?  I'm still trying to get a good handle on these sprites, and could use all the instruction you can give in your lessons! 

Pages: [1]