Hi,

There exists a startTmr command in Basic, but I could not figure out how to use it in Axe (or if it is even supported). IIRC, the calculator has a RTC mapped to an external port, if so, is this accessible through Axe? Or is there another way to stop execution 10 seconds after it begins?


Thanks,
Toraora

Hi all,

When I try writing anything to port, e.g.
3->portthe calculator becomes unusably laggy (~5 sec delays) as soon as the program terminates.
I'm running OS 2.53 on a TI84+ SE.

Is port not functioning as it should, or am I using it incorrectly?

THanks,
toraora