« previous next »
Pages: 1 [2]   Go Down

Author Topic: Using asm( inside a program?  (Read 5240 times)

0 Members and 1 Guest are viewing this topic.

Offline JosJuice

  • LV10 31337 u53r (Next: 2000)
  • **********
  • Posts: 1344
  • Rating: +66/-14
    • View Profile
Re: Using asm( inside a program?
« Reply #15 on: December 21, 2010, 02:37:23 pm »
Quote from: DJ Omnimaga on December 21, 2010, 02:33:14 pm
Does this means a BASIC game using Omnicalc's ExecAsm command would not work in DCS? O.O
It would work in DCS. I was just a bit confused, since real( is used by xLib, and xLib doesn't support ExecAsm( (but Omnicalc does).
Logged

Offline Builderboy

  • Physics Guru
  • CoT Emeritus
  • LV13 Extreme Addict (Next: 9001)
  • *
  • Posts: 5673
  • Rating: +613/-9
  • Would you kindly?
    • View Profile
Re: Using asm( inside a program?
« Reply #16 on: December 21, 2010, 02:41:19 pm »
I think both xLib and Omnicalc use real() functions, but Omnicalc's real functions don't interfere with xLib, so they can both be run at the same time
Logged

Offline DJ Omnimaga

  • Clacualters are teh gr33t
  • CoT Emeritus
  • LV15 Omnimagician (Next: --)
  • *
  • Posts: 55943
  • Rating: +3154/-232
  • CodeWalrus founder & retired Omnimaga founder
    • View Profile
    • Dream of Omnimaga Music
Re: Using asm( inside a program?
« Reply #17 on: December 21, 2010, 02:47:13 pm »
Nah, Omnicalc cannot be ran at the same time. I think Celtic III/Doors CS was made so Omnicalc's ExecAsm will run fine, though, through Celtic III/DCS.
Logged
Pages: 1 [2]   Go Up
« previous next »