« previous next »
Pages: [1]   Go Down

Author Topic: nspire CX CAS bottom port  (Read 9515 times)

0 Members and 1 Guest are viewing this topic.

Offline Menes

  • LV1 Newcomer (Next: 20)
  • *
  • Posts: 6
  • Rating: +0/-0
    • View Profile
nspire CX CAS bottom port
« on: April 20, 2014, 03:30:15 am »
Does anyone knows the pin names/descriptions of the bottom port in the nspire CX CAS? (i guess i would be the same as the non-CAS version, there is a photo to clarify which port i am talking about. Source: http://www.datamath.org/Graphing/JPEG_NSpire_CX_EZ.htm)
Basically, what i want to do is to try to control an external device through this port. My first goal, to keep it simple, is just to turn on/off a led, but i need the info about the pins in order to know which one i should use.

btw, i know i would have to use ndless, with ndless 3.1 is enough? or do you think i would have to use ndless 3.6?

Logged

Offline Hayleia

  • Programming Absol
  • Coder Of Tomorrow
  • LV12 Extreme Poster (Next: 5000)
  • ************
  • Posts: 3367
  • Rating: +393/-7
    • View Profile
Re: nspire CX CAS bottom port
« Reply #1 on: April 20, 2014, 03:53:01 am »
There's that topic on TI Planet dealing with this port. It is in French but it gives a link to an English description of those ports. I personally can't tell you more about those though.
Logged
I own: 83+ ; 84+SE ; 76.fr ; CX CAS ; Prizm ; 84+CSE
Sorry if I answer with something that seems unrelated, English is not my primary language and I might not have understood well. Sorry if I make English mistakes too.

click here to know where you got your last +1s

Offline Streetwalrus

  • LV12 Extreme Poster (Next: 5000)
  • ************
  • Posts: 3821
  • Rating: +80/-8
    • View Profile
Re: nspire CX CAS bottom port
« Reply #2 on: April 20, 2014, 04:32:08 am »
Only few of the pins are known. That said you could use the known ones as gpio indeed.
Logged

Offline Menes

  • LV1 Newcomer (Next: 20)
  • *
  • Posts: 6
  • Rating: +0/-0
    • View Profile
Re: nspire CX CAS bottom port
« Reply #3 on: April 20, 2014, 11:11:53 am »
thanks Hayleia, i already known that hackspire site, but it was a bit confusing because they say that the dock connector is J01, but on my device the dock connector is named J05. I will check that topic on TI planet and try to understand more about all that stuff.

As a side note, i have tried to supply an external led through the mini usb port (i actually used a mini usb adapter to have more space between pins) but an strange error message apears and cut's off the power supply of the mini usb port until i connect another device to it.
The message is as follows: "Disconnect and reconnect the USB peripheral attached to handheld; if problem persists make sure the battery in your Cradle and/or Handheld fully carged or on AC power. If this does not correct the situation the USB peripheral is likely faulty"
« Last Edit: April 20, 2014, 11:26:34 am by Menes »
Logged
Pages: [1]   Go Up
« previous next »